Installation Instructions
Step 1
Remove the black bolt from the bracket. Gently place the bracket over the grab-bar taking care not to pull the bracket ends too far apart.
Installation Instructions
Step 2
Replace the bolt and screw it in a few times.
DO NOT TIGHTEN.
Installation Instructions
Step 3
Carefully slide the bracket up grab-bar as far as it will go. Nip tight the bolt. Do not over tighten as it could damage the bracket.
Installation Instructions
Step 4
With the lead supplied, connect the Micro USB end to into the phone holder. Now connect the standard USB end into the car charger.
Installation Instructions
Step 5
Position the phone holder to suit your preferred viewing angle.
Installation Instructions
Step 6
Whilst securing griping the phone holder with one hand, tighten the nut at the rear of the phone holder with your other hand.
Installation Instructions
Re-adjusting the phone holder position
To re-adjust the phone holders position, loosen the rear nut first. Position the phone holder to suit your preferred viewing angle then re-tighten the rear nut to secure.
DO NOT ADJUST THE PHONE HOLDER POSITION WHEN THE NUT IS TIGHTENED (Any damage or breakage caused to the mounting bracket will not be covered under your warranty)